From 24a74a98afc6cb386f178719010fda9fc94d64eb Mon Sep 17 00:00:00 2001 From: miguel Date: Thu, 21 Aug 2025 04:52:51 +0100 Subject: [PATCH] printer.cfg modified - 21/08/25 - 04:52:45 --- printer_data/config/printer.cfg | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-) diff --git a/printer_data/config/printer.cfg b/printer_data/config/printer.cfg index d8a7545..b301840 100644 --- a/printer_data/config/printer.cfg +++ b/printer_data/config/printer.cfg @@ -24,7 +24,6 @@ ## Obtain definition by "ls -l /dev/serial/by-id/" then unplug to verify ##-------------------------------------------------------------------- serial: /dev/serial/by-id/usb-Klipper_stm32f446xx_41004C000A51313133353932-if00 - #/dev/serial/by-id/usb-Klipper_stm32f446xx_41004C000A51313133353932-if00 restart_method: command ##-------------------------------------------------------------------- @@ -159,7 +158,7 @@ enable_pin: !PG5 # Rotation Distance for TR8x8 = 8, TR8x4 = 4, TR8x2 = 2 rotation_distance: 4 microsteps: 32 -endstop_pin: probe:z_virtual_endstop +endstop_pin: nhk:gpio10 ## Z-position of nozzle (in mm) to z-endstop trigger point relative to print surface (Z0) ## (+) value = endstop above Z0, (-) value = endstop below ## Increasing position_endstop brings nozzle closer to the bed @@ -305,7 +304,7 @@ max_temp: 130 ## For the PROBE port. Will not work with Diode. May need pull-up resistor from signal to 24V. #pin: ~!PB7 ## For the DIAG_7 port. NEEDS BAT85 DIODE! Change to !PG15 if probe is NO. -pin: PG15 +pin: nhk:gpio10 ## For Octopus Pro Probe port; NPN and PNP proximity switch types can be set by jumper #pin: ~!PC5