From 6fa5a5a7bcc7d0e56367301c35b75c3c174da960 Mon Sep 17 00:00:00 2001 From: miguel Date: Fri, 22 Aug 2025 00:49:05 +0100 Subject: [PATCH] printer.cfg modified - 22/08/25 - 00:48:58 --- printer_data/config/printer.cfg | 18 ++++++++++-------- 1 file changed, 10 insertions(+), 8 deletions(-) diff --git a/printer_data/config/printer.cfg b/printer_data/config/printer.cfg index 0baa0cb..e004566 100644 --- a/printer_data/config/printer.cfg +++ b/printer_data/config/printer.cfg @@ -226,9 +226,9 @@ stealthchop_threshold: 0 # Heater - HE0 # Thermistor - T0 [extruder] -step_pin: PE2 -dir_pin: PE3 -enable_pin: !PD4 +step_pin: nhk:gpio23 +dir_pin: nhk:gpio24 +enable_pin: !nhk:gpio25 ## Update value below when you perform extruder calibration ## If you ask for 100mm of filament, but in reality it is 98mm: ## rotation_distance = * / 100 @@ -244,11 +244,12 @@ microsteps: 32 full_steps_per_rotation: 200 #200 for 1.8 degree, 400 for 0.9 degree nozzle_diameter: 0.400 filament_diameter: 1.75 -heater_pin: nhk:gpio9 #-----------------------------------------------------------------------------------------------------------------------------------------Heater Issue +heater_pin: nhk:gpio9 ## Check what thermistor type you have. See https://www.klipper3d.org/Config_Reference.html#common-thermistors for common thermistor types. ## Use "Generic 3950" for NTC 100k 3950 thermistors -sensor_type: ATC Semitec 104NT-4-R025H42G #-----------------------------------------------------------------------------------------------------------------------------------------Thermistor Issue +sensor_type: ATC Semitec 104NT-4-R025H42G sensor_pin: nhk:gpio29 +pullup_resistor: 2200 min_temp: 10 max_temp: 280 max_power: 1.0 @@ -266,10 +267,11 @@ pressure_advance_smooth_time: 0.040 ## E0 on MOTOR6 ## Make sure to update below for your relevant driver (2208 or 2209) [tmc2209 extruder] -uart_pin: PE1 +uart_pin: nhk:gpio0 +tx_pin: nhk:gpio1 interpolate: false run_current: 0.5 -sense_resistor: 0.110 +sense_resistor: 0.100 #previously 0.110 stealthchop_threshold: 0 @@ -350,7 +352,7 @@ samples_tolerance_retries: 3 [fan] ## Print Cooling Fan - FAN0 pin: PA8 # Output pin controlling the fan. This parameter must be provided. -max_power: 0.6 +max_power: 0.4 # This should be set to 0.8 on most motherboards to give full range of control to your slicer. # Anything above 80% duty cycle will be full power on this particular brushless driver. # To fine-tune the max_power parameter for your particular motherboard, set max_power to 1.0, go into the Klipper dashboard, and increase fan speed 1% at a time until the actual fan speed stops increasing as you increase the fan speed. Divide the fan speed at this point by 100 and enter it into the max_power parameter.